MiTek
MiTek IHFL17112 18-Gauge Face-Mount I-Joist Hanger — 1-3/4 x 11-7/8 in
SKU: IHFL17112 | Model Number: IHFL17112
$621 /each
Breaux Bridge
Out of Stock
Check inventory at other locations
In-Store Pick-Up
Delivery Available
Description
MiTek IHFL17112 18-Gauge Face-Mount I-Joist Hanger — 1-3/4 x 11-7/8 in is a face-mount i-joist hanger from MiTek (model/MPN IHFL17112).
Series: IHFL; Material: 18-gauge steel; Finish: G90 galvanizing.
Documents & Resources
- MiTek Product Catalog — 62nd Edition
- Warranty Information
- Code / Evaluation Report
- Product Information
- Doug Ashy Fasteners / Hardware (Decking) Buying Guide
- MiTek IHFL/IHF Series — exact IHFL17112 drawing/load page
Installation
- Use all specified fasteners.
- Position I-joist into hangers and tap or push into place to fully seat joist and engage cleats.
- Web stiffeners are not required unless specified by the I-joist manufacturer.
- Min Nailing – Fill all round nail holes. Max Nailing – Fill all round and diamond holes.
- IHFL – For additional uplift capacity, install (2) 10d (0.148") x 1-1/2" nails through diamond dimple holes into the bottom chord of I-joist member for a total uplift of 220 lbs. IHF – Uplift capacity for hangers installed without joist nails is 65 lbs.
Product Specifications
Additional Uplift | Two 10d x 1-1/2-in nails through diamond dimple holes provide 220-lb total uplift for IHFL family |
Code Resource | Use current MiTek IHFL/IHF code table and exact model drawing/load table |
Finish | G90 galvanizing |
Manufacturer Model | IHFL17112 |
Material | 18-gauge steel |
Max Nailing | Fill all round and diamond holes |
Min Nailing | Fill all round nail holes |
Product Type | Face-Mount I-Joist Hanger |
Seat Cleats | Engage the I-joist bottom flange and eliminate joist nails for base installation |
Series | IHFL |
Supported I-Joist | 1-3/4 x 11-7/8 in |
Temporary Placement | Speed prongs support temporary positioning |
Web Stiffeners | Not required unless specified by the I-joist manufacturer |
